Your cart is empty

lotus T600G GPS version RC UFO with DEVO 10 TX

$809.81
Sold Out


The T600G (with GPS) is a high-end aircraft based on the T580P+ platform. It is meant
to be used for professional aerial photo and video capture.
1.  Safe: Fully independently flight control. Included features are a low voltage alarm
and a lost signal auto return to home function.
2.  Efficient:  14inch  Slow  Fly  propellers  plus  brushless  motors  give  us  maximum
efficiency at 12.2g/W.  
3.  Stable: Using high performance, industrial grade MEMS sensors and 6 DOF motion
control,  our  aircraft  has  a  low  drift  factor.    The  materials  used  to  build  this
aircraft are of the highest quality and impact resistant.  
4.  Simple: Pre-configured with radio control transmitter, no setup required  
5.  Easy  to use:  The  components  are easily assembled  and offer  intuitive operating
commands. Our aircraft are also able  to operate  in  temperatures  ranging  from
14 degrees Fahrenheit to 140 degrees Fahrenheit.



Functions and Features:
1)  Position Hold  
2)  Auto return to home and auto landing (transmitter or ground station control)

The  T600G  uses  four  (4)  brushless  motor,  direct  drive  propellers  to  reach  a
self-stabilizing position hold.  It can also  reach vertical position hold as well as move
left and right, forward and backward and so on. 7
 
The T600G supports most camera gimbals which can now be installed under the frame &
base  plate  to  allow  for  quick  attachment &  removal  from  the  aircraft.  The  tilt  and  roll
angle can be controlled via  the  transmitter . The new gimbal mounting  location helps  in
the elimination of high and low frequency vibration during flight.


LotusRC is proud to announce the arrival of our newest quadcopter, the T600G.  Below is a brief introduction of the T600G.
The T600G will be sold as an ARF unit.  The customer will need to provide their own radio, battery and charger. Below is a brief list of the T600G features.
Manual flight mode – automatic take-off and position hold at take-off
Position hold in the air, auto land and auto return to home
The included compass will calibrate in the air (flying in 7-8 circles to complete the calibration)
Will support dual axis camera gimbals
All camera gimbals will be supported except models by DJI.
GPS control connection provided (when connected to receiver, GPS will automatically setup to manual mode with position hold and auto return to home functions)
Supports all PWM signal ESCs
Batteries supported are 4S and smaller
No low voltage alarm included (a low voltage alarm can be added but the first upgrades, available in September 2013 will include a telemetry module as part of the ground control station software)


Control distance will depend on the transmitter used
LotusRC will introduce improvements/upgrades to the standard configuration in two stages.

Stage 1( available end of September 2013) upgrades include:
Addition of special transmitter configuration (connect the transmitter to the aircraft and the receiver to the PC via included USB port)
Ground Control Software (aircraft serial number required to receive and use).  A PC/Laptop with Windows based software required to use ground control software
The above upgrades allow the pilot to make use of the following functions:
Point and Click flight control (trace flight path on the map and the aircraft will follow the flight path traced)
Telemetry module (voltage, altitude, speed etc.)
Improved control distance of 1 km when using the ground control software

Stage 2 (available end of December 2013) upgrades include:
 Point and Click flight control (trace flight path on the map and the aircraft will follow the flight path traced)
Ground Control Software (aircraft serial number required to receive and use).  A PC/Laptop with Windows based software required to use ground control software
Flight control upgrade.  Connect PC to FC board using USB port
These upgrades will allow waypoint flight control (maximum of 4 waypoints).





Electronics equipments
1.  Maximum output current 50A, 4 pcs brushless motor.
2.  Motor  and  ESC  overload  protection  –  gradual  shutdown  when  ESC
detects overload condition.
3.  GPS+INS Combination navigation system.
4.  Self-stabilized dual axis camera gimbals.

Software system
1. GPS  software  based  on  Android/iOS,  provides  a  powerful  and  very
flexible ground control support system.
2. All  T600G  with  full  functional  test  and  configured  for  optimum
performance.
3. Ongoing system maintenance and upgrade service support program.



Walkera DEVO 10 with receiver RX1002 adopts 2.4GHz Direct Sequence Spread Spectrum (DSSS) technology, with automatic ID binding and ID assignment, It can also be customizedly set as fixed ID code.




Package Inlcudes:
LotusRC T600G RC UFO (
Motor,Propeller,ESC,Flight Controller,GPS)
Transmitter: DEVO 10
Receiver: RX1002
Battery
: 14.8V 10000mAh Battery
Charger: B6 with adapter
Case (size:53*46.5*20cm)

Net Weight: 6.8kg

T600G User Manual.pdf




  • 0 Units in Stock