Your cart is empty

Hobbywing Multi-Function LiPo Battery Protector

$11.50
Add to Cart:



Detail
The protector concentrates three functions in one unit:
 1.  Deep discharge supervision and protection
 2.  Battery voltage measurement
 3.  Abnormal throttle signal supervision and lose-control protection

 


1  Specification

1.1 Size: 32mm(L) * 18mm(W) * 9mm(H)
1.2 Weight: 5g
1.3 Battery Type: 2S Lipo battery
1.4 Low voltage cut-off threshold: 2.6V/Cell, 2.85V/Cell or 3.1V/Cell.
      (The total threshold for a 2S Li-Po battery is 5.2V, 5.7V or 6.2V) 
1.5 Tolerance: 0.05V


2  Features

2.1 Deep discharge supervision and protection
The protector provides reliable protection from the "deadly" deep discharge for your precious Li-Po battery cells. It monitors not only the total voltage of whole battery pack but also the voltage of each cell, so it prevents the weakest cell from being damaged earlier than the other one in the same battery pack. When the voltage is lower than the threshold, the protector will make the motor stop running.
 
2.2 Voltage measurement
There are 3 LEDs on the protector to indicate the voltage of the battery pack.
------------------------------------------------------------------------                      
  #1 LED(Red)     #2 LED(Green)    #3 LED(Green)  
------------------------------------------------------------------------
     If the voltage is more than 7.8V, all of these 3 LEDs light;
     If the voltage is between 7.8V to 7.0V, #1 and #2 LEDs light;
     If the voltage is between 7.0V to the pre-setting threshold, only #1 LED lights;
     If the voltage is lower than the pre-setting threshold, none of these LEDs lights;
 
2.3 Abnormal throttle signal supervision and lose-control protection
The protector continuously monitors the throttle signal. When the throttle signal is normal, the protector will just transfer this signal to the speed controller (Pass this signal to the speed controller without any modification). If the throttle signal is abnormal, the protector will automatically lock the signal at a special level you preset (We call it "Protect Point").  
Note: This function is only valid for AM, FM/PPM receiver, not valid for PCM receiver.


Programmable Items
Uses the SET button to program the following items:
1. Low voltage cut-off threshold: 2.6V/Cell, 2.85V/Cell or 3.1V/Cell.
2. Protect point for throttle signal.

Manuals
A PDF reader is needed to open the user manual. Please click the icon to download it.

User manual


  • 1975 Units in Stock


eStart Your Web Store with Zen Cart(tm)